Skip Main Navigation Skip To Navigation Content
Survey of Market Absorption of Apartments (SOMA)
NOTE TO DATA USERS
The SOMA adopted new ratio estimation procedures in 1990 to derive more accurate estimates of completions.1 This new procedure was used for the first time in processing annual data for 1990. Please use caution when comparing completions in 1990 and following years with those in earlier years.
The U.S. Census Bureau designed the survey to provide data concerning the rate at which privately financed, nonsubsidized, unfurnished units in buildings with five or more units are rented or sold (absorbed). In addition, the survey collects data on characteristics such as number of bedrooms, asking rent, and asking price.
Buildings for the survey came from those included in the Census Bureau's Survey of Construction (SOC).2 For the SOC, the United States is first divided into primary sampling units (PSUs), which are stratified based on population and building permits. The PSUs to be used for the survey are then randomly selected from each stratum. Next, a sample of geographic locations that issue permits is chosen within each of the selected PSUs. All newly constructed buildings with five units or more within sampled places and a subsample of buildings with one to four units are included in the SOC.
For the SOMA, the Census Bureau selects, each quarter, a sample of buildings with five or more units that have been reported in the SOC sample as having been completed during that quarter. The SOMA does not include buildings in areas that do not issue permits. In each of the subsequent four quarters, the proportion of units in the quarterly sample that are sold or rented ("absorbed") are recorded, providing data for absorption rates 3, 6, 9, and 12 months after completion.
Beginning with data on completions in the fourth quarter of 1990 (which formed the base for absorptions in the first quarter of 1991), the Census Bureau modified the estimation procedure and applied the new estimation procedure to data for the other 3 quarters of 1990 so that annual estimates using the same methodology for 4 quarters could be derived. The Census Bureau did not perform any additional re-estimation of past data.
Using the original estimation procedure, the Census Bureau created design-unbiased quarterly estimates by multiplying the counts for each building by its base weight (the inverse of its probability of selection) and then summing over all buildings. Multiplying the design-unbiased estimate by the following ratio-estimate factor for the country as a whole provides the following estimate:
Beginning with January 2001 completions, the SOC revised its methodology for estimating the number of units completed for 5+ multi-unit structures. See http://www.census.gov/ftp/pub/const/www/new_methodology_const.html for these changes. Thus, caution is required when comparing data from 2001 and forward to any estimates prior to 2001.
In the modified estimation procedure, instead of applying a single ratio-estimate factor for the entire country, the Census Bureau computes separate ratio-estimate factors for each of the four geographic regions. Multiplying the unbiased regional estimates by the corresponding ratio-estimate factors provides the final estimates for regions. The Census Bureau obtains the final estimates for the country by summing the final regional estimates.
This procedure produces estimates of the units completed in a given quarter that are consistent with published figures from the SOC and reduces, to some extent, the sampling variability of the estimates of totals. Annual absorption rates are obtained by computing a weighted average of the four quarterly estimates.
Absorption rates and other characteristics of units not included in the interviewed group or not accounted for are assumed to be identical to rates for units about which data were obtained. The non-interviewed and not-accounted-for cases constitute less than 2 percent of the sample housing units in this survey.
ACCURACY OF THE ESTIMATES
The SOMA is a sample survey and consequently all statistics in this report are subject to sampling variability. Estimates derived from different samples would differ from these.
Two types of possible errors are associated with data from sample surveys: non-sampling and sampling.
In general, non-sampling errors can be attributed to many sources: inability to obtain information about all cases in the sample, difficulties with definitions, differences in interpretation of questions, inability or unwillingness of the respondents to provide correct information, and data processing errors. Although no direct measurements of any bias that might result from non-sampling errors has been obtained, the Census Bureau thinks that most of the important response and operational errors were detected during review of the data for reasonableness and consistency.
The particular sample used for this survey is one of many possible samples of the same size that could have been selected using the same design. Even if the same questionnaires, instructions, and interviewers were used, estimates from different samples would likely differ from each other. The deviation of a sample estimate from the average of all possible samples is defined as the sampling error. The standard error of a survey estimate provides a measure of this variation and, thus, is a measure of the precision with which an estimate from a sample approximates the average result from all possible samples.
If all possible samples were selected, if each was surveyed under the same general conditions, and if an estimate and its estimated standard error were calculated from each sample, then:
This report uses a 90-percent confidence level as its standard for statistical significance.
For very small estimates, the lower limit of the confidence interval may be negative. In this case, a better approximation to the true interval estimate can be achieved by restricting the interval estimate to positive values, that is, by changing the lower limit of the interval estimate to zero.
The reliability of an estimated absorption rate (i.e., a percentage) computed by using sample data for both the numerator and denominator depends on both the size of the rate and the size of the total on which the rate is based. Estimated rates of this kind are relatively more reliable than the corresponding estimates of the numerators of the rates, particularly if the rates are 50 percent or more.
In this report, Tables A, B, and C present approximations to the standard errors of various estimates shown. Table A presents standard errors for estimated totals, and Tables B and C present standard errors for estimated percentages for rental apartments and condominiums, respectively. To derive standard errors that would be applicable to a wide variety of items and could be prepared at moderate cost, a number of approximations were required. As a result, the tables of standard errors provide an indication of the order of magnitude of the standard errors rather than the precise standard error for any specific item. Standard errors for values not shown in Tables A, B, or C can be obtained by linear interpolation.
ILLUSTRATIVE USE OF THE STANDARD ERROR TABLES
Table 2 of this report shows that in 2009, there were about 5,200 new 2-bedroom apartments built in the Northeast. Table A shows the standard error of an estimate of this size to be approximately 1,120. To obtain a 90-percent confidence interval, multiply 1,120 by 1.6 and add and subtract the result (1,790) from 5,200, yielding limits of 3,410 and 6,990. The average estimate of these units completed in 2009 may or may not be included in this computed interval, but one can say that the average is included in the constructed interval with a specified confidence of 90 percent.
Table 2 also shows that the rate of absorption after 3 months for these 2-bedroom apartments built in the Northeast is 60 percent. Table B shows the standard error on a 60 percent rate on a base of 5,200 to be approximately 10.8 percent. Multiply 10.8 by 1.6 (yielding 17.3) and add and subtract the result from 60. The 90-percent confidence interval for the absorption rate of 60 percent is from 42.7 percent to 77.3 percent.
Table 2 also shows that the median asking rent for the estimated 5,200 2-bedroom apartments built in the Northeast was $1,209. The standard error of this median is about $92.
Several statistics are needed to calculate the standard error of a median.
The standard error of the median is obtained by using the following approximation:
For this example, the standard error of the median of $1,209 is:
Therefore, 1.6 standard errors equals $147. Consequently, an approximate 90-percent confidence interval for the median asking rent of $1209 is between $1,062 and $1,356 ($1,209 plus or minus $147).
1. See Estimation section.
2. See http://www.census.gov/const/www/newresconstdoc.html#sample for further details on the SOC sample design.