Skip Main Navigation Skip To Navigation Content
Survey of Market Absorption of Apartments (SOMA)
The Survey of Market Absorption (SOMA) is a sample survey and consequently all statistics in the report are subject to sampling variability. Estimates derived from different samples would likely differ from one another.
The standard error of a survey estimate is a measure of the variation among the estimates from all possible samples. It allows the Census Bureau to construct an interval with prescribed confidence that the interval includes the average of the estimates from all possible samples. Estimates of standard errors have been computed from the sample data and are presented in the tables.
90-percent confidence intervals for statistical comparisons can be constructed by using the standard errors found in the tables (see the instructions for calculating 90-percent confidence intervals in the section on "Sampling Errors").
NOTE TO DATA USERS
The SOMA adopted new ratio estimation procedures in 1990 to derive more accurate estimates of completions. Please use caution when comparing the number of completions in 1990 and following years with those in earlier years.
The U.S. Census Bureau designed the survey to provide data concerning the rate at which privately financed, nonsubsidized, unfurnished units in buildings with five or more units are rented or sold (absorbed). In addition, the survey collects data on characteristics such as number of bedrooms, rent, and price.
Buildings for the Survey came from those included in the Census Bureau's Survey of Construction (SOC). For the SOC, the United States is first divided into primary sampling units (PSUs), which are stratified based on population and building permits. The PSUs to be used for the survey are then randomly selected from each stratum. Next, a sample of permit-issuing places is chosen within each of the selected PSUs. Finally, all newly constructed buildings with five units or more within sampled places, as well as a subsample of buildings with one to four units, are included in the SOC.
For the SOMA, the Census Bureau selects, each quarter, a sample of buildings with five or more units that have been reported in the SOC as having been completed during that quarter. The Soma does not include buildings completed in nonpermit-issuing areas. We then obtain information on the proportion of units absorbed 3, 6, 9, and 12 months after completion for units in buildings selected in a given quarter in each of the next four quarters.
The Census Bureau publishes preliminary estimates for a given quarter and may revise these estimates in ensuing quarters. Each quarter, some of the absorption data for some buildings arrives after the deadline for that quarter's report; these late data appear in a revised table in the next quarterly report. Finalized data appears in the H-130, Market Absorption of Apartments annual report.
Beginning with data on completions in the fourth quarter of 1990 (which formed the basis for absorptions in the first quarter of 1991), the Census Bureau modified the estimation procedure and applied the modified procedure to the data for the other three quarters of 1990 so that one could derive annual estimates using the same methodology for four quarters. We have not performed any additional re-estimation of past data.
Before the estimation procedure changed, we formed unbiased estimates by multiplying the counts for each building by its base weight (the inverse of its probability of selection) and then summing over all buildings. Multiplying the unbiased estimate by the following ratio estimate factor for the country as a whole provided the final estimate:
total units in buildings with five or more units in permit-issuing areas as estimated by the SOC for that quarter divided by total units in buildings with five or more units as estimated by the SOMA for that quarter
For the modified estimation procedure, instead of applying a single ratio-estimate factor for the entire Nation, the Census Bureau computes separate ratio-estimate factors for each of the four census regions. Multiplying the unbiased regional estimates by the corresponding ratio-estimate factors provides the final estimates for regions. The Census Bureau obtains the final estimate for the country by summing the final regional estimates.
This procedure produces estimates of the units completed in a given quarter which are consistent with the published figures from the SOC and also reduces, to some extent, the sampling variability of the estimates of totals.
Absorption rates and other characteristics of units not included in the interviewed group or not accounted for are assumed to be identical to rates for units where data were obtained. The noninterviewed and not-accounted-for cases constitute less than 2 percent of the sample housing units in this survey.
ACCURACY OF THE ESTIMATES
Two types of possible errors are associated with data from sample surveys: nonsampling and sampling errors. The following is a description of the nonsampling and sampling errors associated with the SOMA.
In general, nonsampling errors can be attributed to many sources: inability to obtain information about all cases in the sample, difficulties with definitions, differences in interpretating questions, inability or unwillingness of the respondents to provide correct information, and data processing errors. These nonsampling errors also occur in complete censuses. Although no direct measurements of the biases have been obtained, the Census Bureau thinks that most of the important response and operational errors were detected during review of the data for reasonableness and consistency.
The particular sample used for this survey is one of many possible samples of the same size that could have been selected using the same sample design. Even if the same questionnaires, instructions, and interviewers were used, estimates from different samples would likely differ from each other. The deviation of a sample estimate from the average of estimates from all possible samples is defined as the sampling error. The standard error of a survey estimate attempts to provide a measure of this variation among the estimates from the possible samples and, thus, is a measure of the precision with which an estimate from a sample approximates the average result from all possible samples.
As calculated for this survey, the standard error also partially measures the variation in the estimates due to errors in response and by interviewers (nonsampling errors), but it does not measure any systematic biases in the data. Therefore, the accuracy of the estimates depends on the standard error, biases, and some additional nonsampling errors not measured by the standard error. As a result, confidence intervals around estimates based on this sample reflect only a portion of the uncertainty that actually exists. Nonetheless, such intervals are extremely useful because they do capture all of the effect of sampling error and, in this case, some nonsampling error as well.
If all possible samples were selected, if each was surveyed under essentially the same general conditions, if there were no systematic biases, and if an estimate and its estimated standard error were calculated from each sample, then:
Approximately 68 percent of the intervals from one standard error below the estimate to one standard error above the estimate (i.e., the 68-percent confidence interval) would include the average result from all possible samples.
Approximately 90 percent of the intervals from 1.6 standard errors below the estimate to 1.6 standard errors above the estimate (i.e., the 90-percent confidence interval) would include the average result from all possible samples.
Approximately 95 percent of the intervals from two standard errors below the estimate to two standard errors above the estimate (i.e., the 95-percent confidence interval) would include the average result from all possible samples.
This report uses a 90-percent confidence level as its standard for statistical significance.
Beginning with data for completions in the second quarter of 1999, the Census Bureau enacted a new procedure for computing standard errors. The new procedure may result in differences in standard errors from prior methodology, so standard errors were revised back to the third quarter of 1998.
For very small estimates, the lower limit of the confidence interval may be negative. In this case, a better approximation to the true interval estimate can be achieved by restricting the interval estimate to positive values--that is, by changing the lower limit of the interval estimate to zero.
The average result from all possible samples either is or is not contained in any particular computed interval. However, for a particular sample, one can say with specified confidence that the average result from all possible samples is included in the constructed interval.