The install control panel should start automatically, and will install
the SF1 software. After installing the software, the software will note
that it has detected a dataset. You will be given the option of "Full
install" or "Run from disk." "Full install" takes
about 11 megabytes of space on your hard drive and can be a lengthy process.
However, if you will be using these data frequently the full install is
worth the time as the response time of the "full install" is
markedly better than the "Run from disk."
Use the instructions below if the install control panel feature does not
Go to: Start,
then pick Run
Click on Browse
(make sure this
is your DVD drive)
and pick setup.exe
under the SF1_DVD(drive letter:)
Follow the on-screen directions
to complete your installation.
When the SF1 database has been installed, click the LAUNCH
button on the DVD control panel or the SF1 icon located on your desk top
to start the application.