U.S. Department of Commerce

Congressional Apportionment

Skip top of page navigation
You are here: Census.govPeople and HouseholdsCongressional Apportionment MainAbout › About › Computing Apportionment

Computing Apportionment

Article 1, Section 2, of the United States Constitution states:

"Representatives and direct Taxes shall be apportioned among the several States which may be included within this Union, according to their respective Numbers...The actual Enumeration shall be made within three Years after the first Meeting of the Congress of the United States, and within every subsequent Term of ten Years, in such Manner as they shall by Law direct."

Therein lies the primary mandate of the U.S. census, apportionment of the House of Representatives. Since that first census in 1790, five methods of apportionment have been used. The current method used, the Method of Equal Proportions, was adopted by congress in 1941 following the census of 1940. This method assigns seats in the House of Representatives according to a "priority" value. The priority value is determined by multiplying the population of a state by a "multiplier."

For example, following Census 2000, each of the 50 states was given one seat out of the current total of 435. The next, or 51st seat, went to the state with the highest priority value and thus became that state's second seat. This continued until all 435 seats had been assigned to a state. This is how it is done.

Equal Proportions Method

P - represents a state's total population

n - represents the number of seats a state would have if it gained a seat (because all states automatically received one seat the next seat gained is "seat two," and the next "seat three," and the next "seat four," and so on.)

The multiplier equals:
1 divided by the square root of n(n-1)
[which is called the reciprocal of the geometric mean]. Computing these values is quite easy using a PC and a good spreadsheet package.

Thus the formula for calculating the multiplier for the second seat is:
1 divided by the square root of 2(2-1)
or 1/1.414213562 or 0.70710678

the multiplier for the third seat is:
1 divided by the square root of 3(3-1)
1/2.449489743 or 0.40824829

the multiplier for the fourth seat is:
1 divided by the square root of 4(4-1)
1/3.464101615 or 0.288675134

Continue until an appropriate number of multipliers have been calculated.

Once the "multipliers" have been calculated, the next step is to multiply this figure by the population total for each of the 50 states (the District of Columbia is not included in these calculations). The resulting numbers are the priority values. Make sure you compute enough multipliers to cover the largest amount of seats in the U.S. House of Representatives that any one state stands to gain. Multipliers and priority values must be calculated for the largest number of seats assigned to a state. For example, if the largest number of seats assigned to a state is 50, multipliers and priority values must be calculated for the 50th seat. If you are using a PC, compute multipliers for seats 2 through 60. This will assure you have enough multipliers for apportionment.

Once you've calculated priority values for each state for the total anticipated seats, the next step is to rank and number the resulting priority values starting with seat 51 until all 435 seats have been assigned (remember, each state automatically received one seat). Next, tally the number of seats for each state to arrive at the total number of seats in the House of Representatives apportioned to each state.

Multipliers and Priority Values 

Source: U.S. Census Bureau | Congressional Apportionment |  Last Revised: 2013-02-04T07:44:34.737-05:00